Wallplas Arties self-adhesive vinyl mural

Our Wallplas collection of wallpapers and murals are self-adhesive, with the glue already incorporated. Therefore, you will not need to buy extra materials for their placement. They are self-adhesive, and are printed, designed and manufactured by us.

It is very important that the surface where we are going to apply it is dry, free of dust and grease and in good condition.

For installation, you will only need your own hands, a sharp cutter, and masking tape to hold each strip in place while you install it.

 HOW ARE THEY INSTALLED?

Self-adhesive murals have a specific order of placement. Each strip has a panel number identified and in the placement instructions you will see in which position the number is placed. We always start with panel number 1 and it can go up to 6 panels.

Decide where you want to start placing the strips. If you want to start on the left side, start with panel number 1. If you want to start on the right side, reverse the order of the pieces, start with the panel with the highest number and finish with 1. 

INSTALLATION INSTRUCTIONS.

1. Use masking tape (also called painter's tape) to position and hold the strip without removing the protective paper backing.

2. Always leave 10cm of excess at the top because walls and ceilings are never completely straight.

3. Peel off the back paper about 10-20cm and start sticking.

4. Remove the masking tape because the strip is now holding itself in place and start removing the back of the paper as you stick it to the wall, always pressing from the inside out towards the edges.

5. When you reach the end of the strip, cut off the excess with a cutter.

6. The next strip should be mounted approximately 1cm above the one you already have glued.

7. Cut off the excess side and you're done.

The process is very simple, but if you have any questions, please contact us and we will help you.